Omron MicroHAWK ID-40 - Page 23

13.10. Click the "Input Target Variable" (rst line), which denes the input assembly used in the EDS le, and type
103. This eld is circled in red below. Select the Originator Variable, circled in yellow, and select
ID40_Input01 in the dropdown eld. In the RPI eld, circled in green, change this value to 20.0. Note that
the RPI for the ID-40 cannot be set to an amount less than 10 ms.
13.11. Click the "Output Target Variable" (second line), which denes the output assembly used in the EDS le,
and type 197. This eld is circled in red below. Select the Originator Variable, circled in yellow, and select
ID40_Output01 in the dropdown eld.
13.12. Repeat steps 13.8 through 13.11 for the remaining ID-40 readers. When completed, your list should
appear similar to the example below.
23