15.4. Once the issue has been corrected, it may take up to a minute for the Connection Status to update in
SYSMAC Studio.
15.5. Once all the connections are established as shown below, the project should be saved by going to the
File menu and selecting Save As and typing the project name.
15.6. The NJ/NX controller setup is completed.
NA-HMI Panel Setup
NA-HMI Panel Not Present
If your integration of this solution does not include a NA-HMI panel, then the remaining sections of the HA-HMI
panel setup can be skipped.
Establish NA-HMI Panel Communications
16. Establish NA-HMI Panel Communications
16.1. In the current open project, under the words “Multiview Explorer”, click the controller dropdown eld
and select HMI_NA5_0 as shown below.
16.2. Open the HMI menu and select Change Device as shown below.
26
Technical Note: MicroHAWK ID-40 360
º
Barcode Reading Solution
TECHNICAL
NOTE
To Next Page
Loading...
