17
EN
Troubleshooting
Check the following if the device should fail during operation.
Problem Cause Remedy
Nothing happens
when the power switch
is pressed.
Is the AC adapter connected
correctly to a power outlet and
the compressor?
Check that the AC adapter is connected to
a power outlet and the compressor. Unplug
then reinsert the plug if necessary.
No nebulization or
low nebulization rate,
when the power is on.
Is there medication in the
medication tank?
Add the correct amount of medication to
the medication tank.
Is there too much/little
medication in the medication
tank?
Is the vaporizer head missing
or not assembled correctly?
Attach the vaporizer head correctly.
Is the nebulizer kit assembled
correctly?
Assemble the nebulizer kit correctly.
Is the nozzle blocked? Make sure that the nozzle is free of
blockages.
Is the nebulizer kit tilted at a
sharp angle?
Make sure that the nebulizer kit is not tilted
at an angle of more than 45 degrees.
Is the air tube connected
correctly?
Make sure that the air tube is correctly
connected to the compressor and nebulizer
kit.
Is the air tube folded? Make sure that the air tube is not twisted or
bended.
Is the air tube blocked? Make sure that the air tube is free of
blockages.
Is the air filter dirty? Replace the air filter with a new one.
The compressor is
abnormally loud.
Is the air filter cover attached
correctly?
Attach the air filter cover correctly.
The compressor is
very hot.
Is the compressor being
covered?
Do not cover the compressor during
operation.
Note: If the suggested remedy does not solve the problem, do not try to repair the
device - the device are not user serviceable. Return the device to an authorized
OMRON retail outlet or distributor.
To Next Page
Loading...
Need help?
General
