15
Inhalation Method (using optional accessories)
2
Fill the supply medication
bottle with medication.
3
Make sure that there is silicon
packing (Washer) on the inside
of the supply medication bottle
cap and close the cap tightly.
Note: Failure to do so will allow air to leak into
the bottle from the cap, causing the
liquid in the supply medication bottle to
overflow.
4
Remove the cap from the long
time nebulization set’s supply
medication pipe and connect
the supply medication set’s
tubes.
5
Hang the medication supply
bottle in a suitable location, for
example on an IV stand.
Note: Make sure that the tube is not bent.
Medication will not be supplied if the
tube is bent. If the tube is too long, cut it
to a suitable length.
For subsequent steps, see No. 2 under Step
3
in
the “Before Inhalation” section. (
Page 9)
Set the timer to “CONTINUOUS” and adjust the
air-flow volume as desired while observing the
aerosol. Air-flow volumes can also be adjusted by
opening and closing the air volume adjustment
lever.
Note: During extended use, medication will accumulate
in the hose, reducing the nebulization volume. If
this occurs, remove the medication from the
hose.
Supply medication set (U10-11-E)
Supply medication bottle
Cap
Tube
Supply
medication pipe
Supply
medication
pipe cap
Air volume
adjustment
lever
2
3
4
5
Position the air volume adjustment lever
vertically to cut off airflow or horizontally to
allow it.
Closed Opened
To Next Page
Loading...
