EasyManuals Logo

Omron NT User Manual

Omron NT
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
'#
Duringonline transfer command execution, thefollowing error codes may beno-
tified with the Not-Acknowledged Command.
Error code Cause Remedy
F0H (memory full) Insufficient memory during host computer to
PT transfer of screen data.
Replace the screen data memory with one of
a larger capacity.
F1H (command error 1)
Data transfer command received although
no transfer notify command was sent from
the host computer to the PT.
Check the order of the commands and
execute the Online Transfer Command
again.
Online Transfer Command received although
screen data memory is EPROM.
Replace screen data memory with an SRAM
type.
F2H (command error 2) Another command was received during
standby for the Data Transfer Command.
Check the order of the commands and
execute the data transfer again.
F3H (process inter-
rupted)
During data transfer the
or
key was
pressed or a different Online Transfer Com-
mand was received.
Check the order of the commands and
execute the Online Transfer Command
again.
F4H (checksum error) Incorrect checksum Check the checksum.
F9H (screen data
memory error)
Online Transfer Command received although
screen data memory is EEPROM.
Replace screen data memory with an SRAM
type.
&%  )
Section 9-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NT and is the answer not in the manual?

Omron NT Specifications

General IconGeneral
BrandOmron
ModelNT
CategoryRecording Equipment
LanguageEnglish

Related product manuals