TS in-
dica-
tor
NS In-
dica-
tor
FS in-
dica-
tor
P ERR In-
dicator
Sev-
en-
seg-
ment
Indi-
cator
Cause Corrective action
---
1-sec-
ond
inter-
val
--- --- [d5] --
> [iP]
-->
[Re-
mote
IP ad-
dress]
CIP Safety Target Does Not
Exist
Refer to CIP Safety Target
Does Not Exist ( page
12 - 41).
---
1-sec-
ond
inter-
val
--- --- [A0] --
> As-
sem-
bly
No.
Upper
Byte --
> As-
sem-
bly
No.
Lower
Byte
CIP Safety Target Connection
T
imeout
Refer to CIP Safety T
arget
Connection Timeout ( page
12 - 42).
--- ---
1-sec-
ond
inter-
val
--- --- FSoE Master Connection Not
Established Error
Refer to FSoE Master Con-
nection Not Established Error
( page 12 - 34).
---
---
1-sec-
ond
inter-
val
--- --- FSoE Master Connection
T
imeout
Refer to FSoE Master Con-
nection Timeout
( page
12 - 38).
--- ---
1-sec-
ond
inter-
val
--- --- The safety connections are
not established (including
when they are currently being
established).
Wait until processing is com-
pleted.
--- --- ---
--- NX Bus Communications Set-
tings Read Error
Refer to NX Bus Communica-
tions Settings Read Error
( page 12 - 56).
---
--- ---
--- Safety Application Data Read
Error
Refer to Safety Application
Data Read Error (
page
12 - 56).
--- --- ---
--- NX Bus Communications Set-
tings and Safety Application
Data Mismatch
Refer to NX Bus Communica-
tions Settings and Safety Ap-
plication Data Mismatch
( page 12 - 57).
12 Troubleshooting
12 - 8
NX-series Safety Control Unit User's Manual (Z930)
To Next Page
Loading...
