Need help?Do you have a question about the Omron SYSMAC NX series and is the answer not in the manual?
General| I/O Capacity | Up to 2560 I/O points |
|---|---|
| Communication Ports | RS-232C |
| Communication Protocols | EtherNet/IP |
| Operating Temperature | 0°C to 55°C |
| Programming Languages | Function Block Diagram, Sequential Function Chart |
| EtherNet/IP Ports | 1 or 2 |
| Built-in USB Port | 1 |
| Humidity | 10% to 90% (non-condensing) |
| Vibration Resistance | 10 to 57 Hz, 0.075 mm amplitude |
| Built-in RS-232C Port | Optional |
| Storage Temperature | -25°C to 65°C |
| Shock Resistance | 147m/s², 3 times in each direction (X, Y, Z) |
Provides critical warnings regarding power supply handling, fail-safe measures, and voltage/current inputs.
Details safety precautions for installing the Unit, including power supply status and avoiding contact with connector pins.
Provides safety precautions for wiring, including double-checking settings, using correct parts, and handling cables.
Outlines precautions for power supply design, including voltage ranges, current capacity, and external breakers.
Highlights precautions for using the High-speed Analog Input Unit, including orientation and placement restrictions.
Provides precautions for storage, mounting, and wiring, warning against improper locations and static discharge.
Provides an overview of the key features of the NX-series High-speed Analog Input Units.
Explains system configurations for connecting NX Units to CPU Units or Communications Coupler Units.
Describes the various functions supported by the High-speed Analog Input Units.
Details the general and individual specifications for the High-speed Analog Input Units.
Outlines the overall procedure and detailed steps for configuring the unit and creating user programs.
Identifies and describes the names and functions of the physical parts of the High-speed Analog Input Units.
Details restrictions on installation, including orientation and adjacent unit placement for NX Units.
Explains the two types of power supplies for NX Units and their wiring methods.
Describes how to wire the terminals, including screwless clamping blocks and wire preparation.
Provides information on wiring the High-speed Analog Input Units to external devices, including examples.
Describes I/O refreshing between CPU Units and NX Units, and between PCs/CPU Units and Slave Terminals.
Details the voltage input ranges and how analog voltage signals are converted to digital values.
Details the current input ranges and how analog current signals are converted to digital values.
Explains how to configure I/O allocation settings using Sysmac Studio, covering display and setup.
Describes how to set the number of samplings per period to determine the sampling period.
Explains the use of digital filters (low-pass, moving average) to suppress noise and stabilize measurements.
Describes the function for correcting offsets in converted values due to unit deterioration and calibrating the units.
Details how to obtain digital input signal values that trigger analog input signals and the DC time of changes.
Details how to check errors using Sysmac Studio, including current errors, logs, and event codes.
Provides a table of common problems, their assumed causes, and corrections specific to the High-speed Analog Input Units.
To Next Page
