Omron SYSMAC NX series User Manual

A-6
Version Information with CPU Units
This section provides version-related information when connecting Units to a CPU Unit. This section
describes the relationships between the unit versions of each Unit and the CPU Unit, and Sysmac Stu-
dio version, and the specification changes for each unit version of each Unit.
A-6-1
Relationship between Unit Versions of Units
The relationship between the unit versions of each Unit and the CPU Unit, and Sysmac Studio version
are shown below.
Interpreting the Version Combination Table
The items that are used in the version combination table are given below.
Refer to the user’s manual for the CPU Unit for the models of CPU Unit to which NX Units can be
connected.
NX Unit Corresponding unit versions/versions
Model Unit version CPU Unit Sysmac Studio
Model numbers of NX
Units.
Unit versions of NX Units. Unit versions of the CPU
Unit that are compatible
with the NX Units.
Sysmac Studio versions
that are compatible with
the NX Units and CPU
Unit.
Version Combination Table
• With the combinations of the unit versions/versions shown below, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit versions/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version,
support is provided by the oldest available version after the specified version. Refer to the user’
s
manuals for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user’s manual for the CPU Unit.
NX Unit Corresponding unit versions/versions
Model Unit version CPU Unit Sysmac Studio
NX-HAD401 Ver.1.0 Ver. 1.18 Ver.1.23
NX-HAD402
Appendices
A - 51
NX-series Analog I/O Units User’s Manual for High-speed Analog Input Units (W592)
A-6 Version Information with CPU Units
A
A-6-1 Relationship between Unit Versions of Units

Omron SYSMAC NX series Specifications

General

Brand	Omron
Model	SYSMAC NX series
Category	Controller
Language	English