Your blood pressure monitor automatically stores up to 60
measurements, and also calculates average values based on the three
most recent measurements taken within 10 minutes of the last reading. (If
there are only two readings in memory for that period, the average will
be based on two readings. If there is only one reading in memory for that
period, that reading will be displayed as the average value.) To make use
of the memory and average reading functions:
• Set the monitor to the correct date and time before taking a
measurement for the first time, or if the date and time setting has been
reset.
1. When the monitor is switched on for the first
time after inserting batteries, the year digits
(2005) will flash on the display.
2. Press the MEMORY button to advance the
digits one at a time.
NOTE: The range for the year setting is 2005
to 2030. If the year reaches 2030, it
will return to 2005.
3. Press the settings button to confirm the
setting when the desired number appears on
the display.
The year is set and the month digits flash on
the display.
SETTING THE DATE AND TIME
11
To Next Page
Loading...
Need help?
General
