EN5
Display/Problem Possible Cause Solution
appears
The monitor has malfunctioned. Press the [START/STOP] button again. If “Er” still appears, contact
your OMRON retail outlet or distributor.
appears
The monior cannot connect to a smart
device or transmit data correctly.
Follow the instructions shown in the “OMRON connect” app.
If the “Err” symbol still appears after checking the app, contact
your OMRON retail outlet or distributor.
flashes
The monitor is waiting for pairing with
the smart device.
Refer to section 5 of instruction manual for pairing your
monitor with your smart device, or press [START/STOP] button
to cancel pairing and turn your monitor off.
flashes
The monitor is ready to transfer your
readings to the smart device.
Open the “OMRON connect” app to transfer your readings.
flashes
More than 48 readings are not
transferred.
Pair or transfer your readings to the “OMRON connect” app so
you can keep them in memory in the app, and this error symbol
disappears.
The date and time is not set.
appears
There are 60 readings in memory to be
transferred
flashes
Batteries are low. Replacing all 4 batteries with new ones is recommended. Refer
to section 4 of instruction manual .
appears or the
monitor is turned
off unexpectedly
during a
measurement
Batteries are depleted. Immediately replace all 4 batteries with new ones. Refer to
section 4 of instruction manual
.
Nothing appears on the
display of the monitor.
Battery polarities are not properly
aligned.
Check the battery installation for proper placement. Refer to
section 4 of instruction manual
.
Readings appear too high or
too low.
Blood pressure varies constantly. Many factors including stress, time of day, and/or how you apply the arm
cuff, may affect your blood pressure. Review section 2 of instruction manual
.
To Next Page
Loading...
Need help?
General
