Omron Z - Page 24

F-180 General-purpose Basic Switch Z
Reverse Short Hinge Roller Lever
Note: The pin plungers of reverse-type models are continuously pressed by the actuator levers with compression coil springs and the pin plungers
are freed by operating the levers. Reverse-type models are highly vibration- and shock-resistive because the pin plungers are normally
pressed.
Reverse Hinge Roller Lever
Note: The pin plungers of reverse-type models are continuously pressed by the actuator levers with compression coil springs and the pin plungers
are freed by operating the levers. Reverse-type models are highly vibration- and shock-resistive because the pin plungers are normally
pressed.
OF max.
RF min.
OT min.
MD max.
5.69 N {581 gf}
1.67 N {170 gf}
2 mm
0.28 mm
FP max.
OP
31.8 mm
29.4±0.4 mm
18.5R
Z-15GM2255-B
9.5 dia. × 4 (plastic roller)
t = 1 (stainless-steel lever)
4.2
+0.075
dia. hole
−0.025
4.36
+0.1
dia.
−0.05
OF max.
RF min.
OT min.
MD max.
2.65 N {270 gf}
0.55 N {56 gf}
4 mm
0.64 mm
FP max.
OP
35 mm
30.2±0.8 mm
40.6R
Z-15GM255-B
9.5 dia. × 4 (plastic roller)
Note: Stainless-steel lever
4.2
+0.075
dia. hole
−0.025
4.36
+0.1
dia.
−0.05
t = 1
(see note)