F-160 General-purpose Basic Switch Z
Note: The pin plungers of reverse-type models are continuously pressed by the actuator levers with compression coil springs and the pin plungers
are freed by operating the levers. Reverse-type models are highly vibration- and shock-resistive because the pin plungers are normally
pressed.
Minimum Order Lot
The following models are available at the minimum order lot specified below. Orders must be placed per lot.
Split-contact Models
Solder terminal Z-15GW54 --- --- ---
Screw terminal Z-15GW54-B
Solder terminal Z-15GW2277 --- --- ---
Screw terminal Z-15GW2277-B
Solder terminal Z-15GM --- --- ---
Screw terminal Z-15GM-B
Solder terminal Z-15GM22 --- --- ---
Screw terminal Z-15GM22-B
Solder terminal Z-15GM2 --- --- ---
Screw terminal Z-15GM2-B
Actuator Standard High-sensitivity High-capacity Micro load
G (0.5 mm) H (0.25 mm) E (1.8 mm) H (0.25 mm)
Hinge cross
roller lever
Unidirectional short
hinge roller lever
Reverse hinge lever
(see note)
Reverse short hinge
roller lever (see note)
Reverse hinge roller lever
(see note)
Actuator Standard High-sensitivity Minimum order lot (pcs)
G (0.5 mm) H (0.25 mm)
Short spring plunger Z-15GD-B --- 10
Panel mount plunger Z-15GQ
Z-15GQ-B
Z-15GQ8-B
---
Panel mount roller plunger Z-15GQ22
Z-15GQ22-B
---
Panel mount cross roller plunger Z-15GQ21-B ---
Short hinge lever Z-15GW21-B ---
Hinge lever Z-15GW
Z-15GW-B
---
Low-force hinge lever Z-15GW4-B Z-15HW24-B
Low-force hinge wire lever --- Z-15HW78-B
Short hinge roller lever Z-15GW22
Z-15GW22-B
---
Hinge roller lever Z-15GW2
Z-15GW2-B
---
Reverse short hinge roller lever Z-15GM22-B ---
Reverse hinge roller lever Z-15GM2-B ---
Actuator F (1.0 mm)
Solder terminal ---
Screw terminal Z-10FY-B
Solder terminal ---
Screw terminal Z-10FSY-B
Solder terminal ---
Screw terminal Z-10FDY-B
Medium OP Solder terminal ---
Screw terminal Z-10FQY-B
Pin plunger
Slim spring plunger
Short spring plunger
Panel mount plunger
To Next Page
Loading...
Need help?
General
