13
External Wiring Setup
1 Connect the Light to your control computer using the provided
USB cable. If you need to use a USB extension cable, make sure
the extension cable is in good condition and all connections are
rmly made.
It is not recommended to have your control computer
farther than 15 feet (4.5 m) away from the laser to avoid
potentially dangerous interference to the control signals.
2 Plug the control board into a stable, compatible, and well
grounded outlet. Turn the laser key and press the power button.
The Light’s fan and light should turn on automatically. Leave
the engraver on and connected during installation of its control
soware.
To Next Page
Loading...
