One Control Tire Linc - Pairing Alert Indicator to Repeater; Initiate Pairing and Status Check; Link Indicator to Repeater

Pairing Alert Indicator to Repeater
1. Pair the Alert Indicator (Fig.1)
to the Repeater by pressing and
releasing the Alert Indicator button
(Fig.1A).
A. The Indicator will power up and
its LED (Fig.1B) will blink red once
then blue three times indicating the
Alert Indicator is NOT linked to the
repeater.
NOTE: After 10 seconds, the Indicator
will enter sleep mode.
2. Link the Alert Indicator to the
Repeater by pressing and holding
the Pair Mode button (Fig.2A) on the
Repeater for at least ve seconds until
the Status LED blinks rapidly.
A
B
Fig.1
Fig.2
A
3