6
Searching For Your Code
If your device does not respond to the remote control
after trying all codes listed for your brand, or if your
brand is not listed at all, try searching for your code.
NOTE: Before performing a code search for a DVD
player or a VCR, turn on the device and insert the
required media.
For example, to search for a code for your TV:
1. On the remote control, press TV once.
2. Press and hold SET until the LED (red light) blinks
twice, then release SET.
3. Enter 9 - 9 - 1. The LED will blink twice.
4. Aim the remote control at the TV and slowly
alternate between pressing PWR (Power) and TV.
Stop when the TV turns off (after pressing PWR).
If the device does not have a Power key, you can
substitute another function, such as digits 0 ~ 9, CH
+, or PLAY).
NOTE: In the search mode, the remote control sends
IR codes from its library to the selected device,
starting with the most popular code first.
5. To lock in the code, press and release SET. The LED
will blink twice.
6. To search for the codes of your other devices, repeat
steps 1 through 5, but substitute the appropriate
device key for the device you are searching for.
6. Repeat steps 1 through 5 for each device you want
to control. For future reference, write down each
working device code in the following boxes:
VCR Code:
Device Type:______________
DVD Code:
Device Type:______________
CBL/SAT (DTC) Code:
Device Type:______________
TV Code:
Device Type:______________
Checking the Codes
If you have set up the remote control using the
Searching For Your Code procedure above, you may
need to find out which four-digit code is operating your
equipment.
For example, to find out which code is operating
your TV:
1. On the remote control, press TV once.
2. Press and hold SET until the LED (red light) blinks
twice, then release SET.
To Next Page
Loading...
Need help?
General
