ONE100 - Installation Manual
23
4 Interface Description
4.1 LAN 100 Mbps Interface (ETHERNET)
4.1.1 Characteristics
• 100Base-TX,
• Full duplex,
• Auto-negotiation.
• Auto MDI/MDX
The Ethernet interface of the ONE100 only supports the 100 Mbps full-
duplex operations in auto-sense mode. If connected to devices in 10 mbps
or half-duplex, the ONE100 interface will not be connected. The problem can
appear mostly with devices forced in such mode or with old Ethernet hub.
4.1.2 Meaning of LED Colors
Lit green Led Link active
Blinking yellow Led Traffic in progress
4.1.3 Connector Pinout
RJ45 Connector:
Pin Signal Pin Signal
1 TD (+) 5 NC
2 TD (-) 6 RD (-)
3 RD (+) 7 NC
4 NC 8 NC
4.1.4 Cables
A standard Ethernet cable is needed (shielded UTP Cat. 5).
To Next Page
Loading...
