OneAccess ONE100 - Console Port (CONSOLE)

ONE100 - Installation Manual
24
4.2 Console port (CONSOLE)
4.2.1 Characteristics
• RS 232,
• 9600 bps,
• 8 bits, 1 bit for stop, no parity.
4.2.2 Connector Pinout
RJ45 Connector:
Pin Signal Pin Signal
1 TX 5
NC
2 RX 6
Cable type
3 GND 7
CTS
4 NC 8
RTS
- TX: Transmission
- RX: Reception
- NC: Not connected
- GND: Ground
- CTS: Clear-To-Send
- RTS: Ready-To-Send
A console cable for router configuration and maintenance only requires TX, RX and
GND to be connected.
If the pin 6 is connected to the ground (pin 3), the cable is then identified as a cable
connected to an asynchronous terminal. In that case, CTS and RTS can be used.
4.2.3 Cables
The console cable is defined in Appendix A.