ONE100 - Installation Manual
35
4.9.2 Connector Pinout
4.9.2.1 Mother board connectors
The connection to the BRI accesses is made on the rear panel via RJ-45
connectors. The RJ45 connector pinout is:
Pin Signal Pin Signal
1 NC 5 TX (-)
2 NC 6 RX (-)
3 RX (+) 7 NC
4 TX (+) 8 NC
4.9.2.2 Daughter board connectors
The connection to the BRI accesses is made on the rear panel via RJ-45
connectors. The RJ45 connector pinout is:
Pin Signal Pin Signal
1 NC 5 RX (-)
2 NC 6 TX (-)
3 TX (+) 7 NC
4 RX (+) 8 NC
To Next Page
Loading...
