ONE100D/M Chapter 4
Installation Guide Interface description
46
4.7 Console port specifications
• Connector: RJ45 (EIA/TIA 568B)
• Data:
-RS232
- 9600 bps
- 8 data bits
- no parity
- 1 stop bit
The following table shows the connector layout of the RJ45 Console connector:
• A console cable for router configuration and maintenance only requires TX, RX and GND to be con-
nected; refer to Annex A: - Console cable on page 64 for more information about the cable.
• If pin 6 is connected to ground (pin 3), the cable is then identified as a cable connected to an asyn-
chronous terminal. In that case, CTS and RTS can be used.
Pin Abbreviation Signal DCE Figure
1 RD Received data Out
2 TD Transmitted data In
3 GND Ground -
4 NC Not connected -
5 NC Not connected -
6 Cable type -
7 RTS Request To Send In
8 CTS Clear To Send Out
To Next Page
Loading...
