ONE100D/M Chapter 7
Installation Guide Powering up the ONE100D/M
60
7 Powering up the ONE100D/M
Power up
To power up the ONE100D/M, always follow these steps:
• Connect the DC power input jack from the power supply to the DC power input of the rear panel of
the router.
• Connect the power supply to the AC mains (100-240 V AC).
Self test
A few seconds after the power is switched on, the ONE100D/M performs a series of self-tests and loads
the software into memory (RAM), during which the Status LED on the front panel blinks.
At the end of the software loading, after about 30 seconds, if:
• the Status LED remains green continuously, it means that the software initialization was successful.
• the Status LED blinks, it means that:
- the software was absent,
or,
- there was an error during the software loading process.
Refer to the OneOS User Manual for more information.
To Next Page
Loading...
