OneAccess ONE300 - Connection

ONE300 – Installation Manual
26
5.3 Connection
The external power supply is connected on the rear panel of the device.
The external power supply is delivered with the router package.
• Connect the ’jack’ connector of the external power supply to the DC “12V –
2,2A” power input device connector,
• Connect the DC input jack from the power supply to the DC “12V-2,2A” power
input on the rear panel of the router,
• Secure the power supply connection by installing the DC power supply cord
into the plastic ring.
The device shall not be used with another power supply than a power
supply provided by OneAccess.