ONE80 – Installation Manual
16
4.4 Switch Interface (SWITCH)
4.4.1 Safety level of Switch interface
The Ethernet 10/100 Mbps auto-sense has a ’SELV’ (Safety Extra Low Voltage)
interface.
They must be used only for indoor applications, connected to a 10/100 Mbps
interface, which has also the ’SELV’ characteristics.
4.4.2 Characteristics
The Ethernet Switch function offers 4 additional Ethernet ports. Each of this port can
be switched and/or routed.
• 10/100 Mbits/s,
• Half or full duplex,
• Auto-negotiation,
• Auto MDI/MDIX.
4.4.3 Meaning of LED colors
Green LED Lit Link active
Blinking yellow LED Traffic in progress
4.4.4 Connector Pinout
RJ45 connector:
Pin Signal Pin Signal
1 TD (+) 5 NC
2 TD (-) 6 RD (-)
3 RD (+) 7 NC
4 NC 8 NC
4.4.5 Cables
The cables are shielded, crossover/straight cables with 4 twisted pairs. The switch
supports auto detection of crossover/straight cable (’auto-MDI/MDI-X detection’); the
transmission pairs are (1-2) and receive (3-6).
To Next Page
Loading...
