ONE80 – Installation Manual
18
6 Power-up
To power up the device, always follow these steps:
• Connect the DC power input jack from the power supply to the DC power
input of the rear panel of the router,
• Connect the power supply to the AC mains (100-240 V AC).
The connection of the power supply causes the switch-on of the equipment.
Few seconds after power-on, the device performs a series of self-tests and loads
the software into memory (RAM), during which the ’STATUS’ LED on the front
panel blinks:
• The ’STATUS’ LED light remains steady green if software initialization was
successful,
• The ’STATUS’ LED blinks in case of software absence or error during
software loading.
Refer to the Software and ONEOS User Guide for more information.
To Next Page
Loading...
