Fix the charging station with four
stakes.
Note: Before xing the charging station on the lawn, please examine the lawn
and decide the best location which is easy for the mower to nd the station
for recharge.
Virtual wire installation
The virtual wire can be installed in one of the following ways.
Securing the wire to the ground with pegs
It is preferable to staple down the virtual wire, if you want to make adjustments to the
virtual wire during the rst few weeks of operation.
Bury the wire
It is preferable to bury the virtual wire if you want to dethatch or aerate the lawn.
If necessary both methods can be combined so one part of the virtual wire is stapled
down and the remainder is buried.
Dig virtual wire with pegs 1 meter per piece in straight-line. Dig corner as picture.
Add pegs in order to pull the virtual wire down to the ground surface, below the grass tips.
Note: Hard or dry ground may cause pegs to break when driving them in. In
extreme cases, watering the lawn where the pegs will be driven.
36
To Next Page
Loading...