Warning: Danger of electric shock
Never use a high-pressure washer or even running water to clean the robot.
Mainenance and Storage
Cleaning of the mower
• Clean all the outside surfaces of the robot with a spong soaked in
warm water.
• Do not use solvents or benzene so not to damage the varnished sur-
faces and the plastic components.
• Do not wash the inside parts of the robot and do not use water jets
in pressure so not to damage the electric and the electronic compo-
nents.
• Check the lower part of the robot (cutting blade area and wheels) and
remove the deposits and/or residues that might obstruct the correct
functioning of the robot.
• To remove the deposits and/or other residues from the blade, use a suitable brush.
• Clean the outside of the charging station from any accumulated residues.
• Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condi-
tion.
• Replace worn or damaged parts for safety.
• Ensure that only replacement cutting means of the right type are used.
• Ensure that batteries are charged using the correct charger recommended by the man-
ufacturer.
• Incorrect use may result in electric shock, overheating or leakage of corrosive liquid
from the battery.
Storage
• Packed the mower and all spare parts with the original package, and storage the carton
o the ground in a cool, dry place. Temperature should not be colder than -4 F°(-20
°C).
Blade replacement
1. Stop the robot in safety conditions.
2. Wear protective gloves.
3. Turn the Robot upside down.
4. Unscrew the blade and remove it.
5. Replace a new blade and screw it.
6. Turn the mower to upside.
45
To Next Page
Loading...