EasyManua.ls Logo

Onewheel+ pint - Using Simplestop for Dismounting; Simplestop Procedure

Onewheel+ pint
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
SIMPLESTOP™ (OPTIONAL)
With Simplestop™ turned on, slow down to a stop by
leaning backward to decelerate. Once stopped, slowly
lean back, the board will travel a few inches backwards
then the tail of the board will gently lower to the ground.
CAUTION: To use Simplestop™, it must be turned on
in the Onewheel App on your smartphone.
WARNING: Never step off with your back foot first
(the foot not on the rider-detection area). This
increases risk of a fall and possible injury.
When Simplestop™ is TURNED ON in the settings on
your Onewheel App, lean back to slow the board down
to a stop.
TIP: To Simplestop™ smoothly shift back with
your hips and knees while keeping your chest
over the center of the tire.
1)
Level out. Once stopped bring your board parallel to
the ground (level).
Lean back and lower. SLOWLY lean back, the board
will travel backwards a couple inches then disengage
and the tail will lower to the ground.
0 mph
RIDING YOUR ONEWHEEL PINT
2) 3)