59
LIGHTBAR COLOR # OF BLINKS DESCRIPTION
03 Overcharged
04 Invalid power-up orientation
06 Motor stall detected
07 Out of range controller temperature
09 Bad accelerometer
10 Bad controller
11 Bad hall sensors
13, 14 Over-current detected
15 Footpad sensor pressed on power-up
16,22 Invalid hardware
17 Out of range battery temperature
18 Out of range motor temperature
21 Charger connected
The different blink codes, differentiated by the
number of blinks in a row, may indicate different
issues with your Onewheel Pint. The entire Lightbar
will blink yellow or red. If you are riding the board
when an error code occurs the board will give
extreme push back. Lean back to slow down, stop
and dismount immediately.
Always count the error code if one occurs. Sometimes
you can solve the issue by charging the battery or by
switching your Onewheel Pint OFF and then ON again.
If you are still experiencing problems, please contact
Onewheel customer support at 1-800- 283-7943 or
send an email to support@onewheel.com
DECODING YOUR ONEWHEEL PINT
BLINKING YELLOW
A minor issue that may be fixed by
charging or switching your board
off and on again.
BLINKING RED
An issue that may require you to
contact customer support.
GETTING TO KNOW YOUR ONEWHEEL PINT
To Next Page
Loading...