98
OPERATIONS OPERATIONS
Turbo MODE:
SLEEP Operation:
To switch on Sleep operation, Press "SLEEP" button once on remote.
Remote display will shows the “ “ symbol. After setting sleep mode, 5 seconds after
display will be goes off. In this mode, Fan speed will be in Low Speed only. After selection of
SLEEP Mode if you press fan speed button, fan speed will change as per the selection unless
it will be in low speed only.
O
In cool mode, after Sleep mode is set, your AC increases the set temp. by 1 C for every hour
that it operates,
O
After 2 hours and after the increase in set temp. by 2 C your AC maintains the temp. at that
level without further increase.
To cancel the Sleep mode, keep press the "SLEEP" button again.
LOCK Button: Press “LOCK” button to lock in all the current settings.
Remote display will shows the “ “ symbol. To release settings, press LOCK button again.
Pressing Turbo key on remote, remote will display symbol “ “ and activates the Turbo
function and air conditioner goes to powerful cooling. During this Mode temperature can be
changed and fan speed cannot be changed. In this mode the AC works on high fan speed.
Turbo mode will operational only in COOL mode. Press again Turbo button to cancel this
operation.
i-Cool:-
When you press i-cool button on remote, will be displayed on Indoor unit.
This mode is activated by pressing i-cool key on remote.
In this mode initially the AC start in special mode at super high speed designed to give
instant cooling and comfort. Compressor will start immediately in this mode. While AC is in
this mode temp, Fan Speed, Timer, Sleep keys are inactive and these parameters cannot be
changed.
To quit i-cool mode Press MODE or TURBO Button.
cool
SWING Operation:
Your split AC has oscillating louvers for uniform cooling around your room.
You can stop the oscillation if you so desire.
Up/Down Air Direction Adjustment:
Press the “H.SWING” button to adjust the Air flow direction UP / Down for continuous
swing “ “ shows on remote LCD.
Press the “H.SWING” button Twice to keep louver at desired position, remote LCD
shows “ “.
VERTICAL SWING Button:
To adjust the left/right air louver direction
press V.SWING button.
Emergency Operation Switch:
In case the batteries in the remote are worn out, or remote is faulty or missing, use
emergency operation switch (*) to ON/OFF AC.
0
In Emergency operation unit will run at preset temperature of 25 C and in AUTO Mode.
To access emergency switch, open the grill as
shown in the figure.
To Next Page
Loading...
