98
OPERATIONS
The FAN Mode:
1. Press "MODE" button to cyclically step through the AUTO-COOL-DRY-FAN modes and stop
when FAN mode is selected.
2. symbol can be seen on the Remote panel when you select the FAN mode.
3. In FAN mode, only Indoor FAN will run at set speed and Compressor & Outdoor Fan will
remain off. Temperature will be displayed on indoor unit as well as remote. Temperature
setting can be changed.
4. In this mode, you can change the Indoor FAN Speed.
TIMER Operation:
You can program your split AC to switch itself ON or OFF at particular time.
Maximum set time is 24 hrs, with 1.0 hr increment .
ON TIMER:
When the AC is "OFF" (in standby), press "TIMER" Button on remote to use this feature as the
TIMER. (make sure that MCB switch is "ON". The "TIMER" light on Indoor unit will glow ON.
.
For EXAMPLE:
Suppose you want to switch ON the AC after 8 hrs. Press "TIMER" button, when AC is in OFF
condition.
Press "TIMER" button to set ON timer. Display on Remote will show "8”.
OFF TIMER:
When the AC is "ON", press "TIMER" Button on remote to use this feature as
the TIMER. The "TIMER" light on Indoor unit will glow ON.
For EXAMPLE:
Suppose you want to switch OFF the AC after 8 hrs. Press "TIMER" button, when AC is in ON
condition.
Press "TIMER" button to set OFF timer. Display on Remote will show "8”.
CANCEL TIMER:
If you want to cancel either TIMER ON or TIMER OFF, press the TIMER button till the timer
becomes blank.
The FAN Mode:
OPERATIONS
Turbo MODE:
SLEEP Operation:
To switch on Sleep operation, Press "SLEEP" button once on remote.
Remote display will shows the “ “ symbol. After setting sleep mode, 5 seconds after
display will be goes off. In this mode, Fan speed will be in Low Speed only. After selection of
SLEEP Mode if you press fan speed button, fan speed will change as per the selection unless
it will be in low speed only.
O
In cool mode, after Sleep mode is set, your AC increases the set temp. by 1 C for every hour
that it operates,
O
After 2 hours and after the increase in set temp. by 2 C your AC maintains the temp. at that
level without further increase.
To cancel the Sleep mode, keep press the "SLEEP" button again.
LOCK Button: Press “LOCK” button to lock in all the current settings.
Remote display will shows the “ “ symbol. To release settings, press LOCK button again.
Pressing Turbo key on remote, remote will display symbol “ “ and activates the Turbo
function and air conditioner goes to powerful cooling. During this Mode temperature can be
changed and fan speed cannot be changed. In this mode the AC works on high fan speed.
Turbo mode will operational only in COOL mode. Press again Turbo button to cancel this
operation.
i-Cool:-
When you press i-cool button on remote, will be displayed on Indoor unit.
This mode is activated by pressing i-cool key on remote.
In this mode initially the AC start in special mode at super high speed designed to give
instant cooling and comfort. Compressor will start immediately in this mode. While AC is in
this mode temp, Fan Speed, Timer, Sleep keys are inactive and these parameters cannot be
changed.
To quit i-cool mode Press MODE or TURBO Button.
cool
To Next Page
Loading...
