1110
OPERATIONS
SWING Operation:
Your split AC has oscillating louvers for uniform cooling around your room.
You can stop the oscillation if you so desire.
Up/Down Air Direction Adjustment:
Press the “H.SWING” button to adjust the Air flow direction UP / Down for continuous
swing “ “ shows on remote LCD.
Press the “H.SWING” button Twice to keep louver at desired position, remote LCD
shows “ “.
VERTICAL SWING Button:
To adjust the left/right air louver direction
press V.SWING button.
Emergency Operation Switch:
In case the batteries in the remote are worn out, or remote is faulty or missing, use
emergency operation switch (*) to ON/OFF AC.
0
In Emergency operation unit will run at preset temperature of 25 C and in AUTO Mode.
To access emergency switch, open the grill as
shown in the figure.
GENERAL INSTRUCTIONS FOR
INSTALLATION
Locating the indoor and outdoor units
properly will help optimise the performance of
your airconditioner. While your Onida /
Dealer's Technician will be happy to guide you
on the best location for your airconditioner,
here are a few helpful hints.
Locating the Indoor Unit
• Locate the IDU for the best cool air
circulation. Preferably, there should be
no obstructions nearby, as shown in the
adjacent figure.
• Do not locate the unit directly opposite a
door which is opened frequently. The
cold air will go out of the room each time
the door is opened, as shown in the
adjacent figure.
• All indoor units will form condensate water.
Please ensure that the condensate can
be drained out of the room to a toilet /
pantry, etc. The installation engineer will
make sure that a "U" bend is provided in
the drain to prevent insects from coming
into the room through the drain tube, as
shown in the adjacent figure.
To Next Page
Loading...
