En
4
12. Region Codes—The BD/DVD standard
uses region codes to control how discs can
be played around the world, the world being
divided into three regions (BD) or six regions
(DVD). This unit will only play BD/ DVD discs
that match its region code, which can be found
on its rear panel.
13. About this Manual—This manual explains
how to use all of this unit’s functions. Although
the BD/DVD standard offers many special
features, not all discs use them all, so
depending on the disc being played, this unit
may not respond to certain functions. See the
disc’s sleeve notes for supported features.
This unit contains a semiconductor laser
system and is classi ed as a “CLASS 1 LASER
PRODUCT”. So, to use this model properly,
read this Instruction Manual carefully. In case of
any trouble, please contact the store where you
purchased the unit.
To prevent being exposed to the laser beam, do
not try to open the enclosure.
CAUTION:
CLASS 1M VISIBLE AND INVISIBLE LASER
RADIATION WHEN OPEN. DO NOT VIEW
DIRECTLY WITH OPTICAL INSTRUMENTS.
THIS PRODUCT UTILIZES A LASER. USE
OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
The label on the right is
applied on the rear panel.
1. This unit is a CLASS 1
LASER PRODUCT and
employs a laser inside
the cabinet.
2. To prevent the laser from being exposed,
do not remove the cover. Refer servicing to
quali ed personnel.
For British models
Replacement and mounting of an AC plug on the
power supply cord of this unit should be performed
only by quali ed service personnel.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked with the
letter L or coloured red.
IMPORTANT
The plug is tted with an appropriate fuse. If the
fuse needs to be replaced, the replacement fuse
must approved by ASTA or BSI to BS1362 and
have the same ampere rating as that indicated on
the plug. Check for the ASTA mark or the BSI mark
on the body of the fuse.
If the power cord’s plug is not suitable for your
socket outlets, cut it off and t a suitable plug. Fit a
suitable fuse in the plug.
For European Models
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
declare in own responsibility,
that the ONKYO product
described in this instruction manual is in compliance with
the corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
K. MIYAGI
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH.
To Next Page
Loading...
Need help?
General
