En
46
Update process
1. When this player is turned on, the Internet
connection starts automatically.
• “Accessing...” blinks on the screen.
• The current version of this unit software and
the latest version of the update le on the
network are displayed when latest version of
rmware has been found.
To update this player software with update
le, select “Yes”, and go to step 2.
Latest version of firmware has been found.
Firmware update is available.
Proceed with update?
If “Yes” will be selected, version update will start.
Current Version :
Latest Version :
xxxxxxxxxx
yyyyyyyyyy
Yes
No
• If the latest rmware version has been
already updated, nothing is displayed on the
screen.
2. Press ENTER to start updating.
Downloading latest firmware…
Version : yyyyyyyyyy
30%
3. When the software is successfully updated, a
screen is displayed indicating that the update
process is completed.
• If the update has failed, an error message
appears. Retry the update after checking if
the broadband Internet connection (Page 18)
and communication settings (Page 43) are
performed properly.
4. Press
to turn off the player before using
again.
Manual Update from Network
This function allows you to perform the update
operation by accessing an Internet connection
manually to check if there is a new rmware
version.
NOTE
• Make sure that the LAN cable is connected to
this player (see page 18).
• Make sure to perform the communication
settings (see page 43).
1. Press / to select “Settings”, then press
or ENTER.
2. Press / to select “Software Update
Settings”, then press or ENTER.
3. Press / to select “Manual Update”, then
press
or ENTER.
4. Press / to select “Network”, then press
ENTER.
5. During access to the network and checking the
latest version of rmware, “Accessing...” blinks.
• The current version of this unit software and
the latest version of the update le on the
network are displayed when latest version of
rmware has been found.
To update this player software with update
le, select “Yes”, and go to step 6.
Latest version of firmware has been found.
Firmware update is available.
Proceed with update?
If “Yes” will be selected, version update will start.
Current Version :
Latest Version :
xxxxxxxxxx
yyyyyyyyyy
Yes
No
To Next Page
Loading...
