En
47
• If the Internet connection has failed, an error
message appears.
Retry the update after checking if the
broadband Internet connection (Page 18)
and communication settings (Page 43) are
performed properly.
6. Press ENTER to start updating.
Downloading latest firmware…
Version : yyyyyyyyyy
30%
7. When the software is successfully updated, a
screen is displayed indicating that the update
process is completed.
• If the update has failed, an error message
appears.
Retry the update after checking if the
broadband Internet connection (Page 18)
and communication settings (Page 43) are
performed properly.
8. Press
to turn off the player.
Manual Update from USB
memory device
This function allows software updates by inserting
a USB memory device with the update le into the
USB (front) or USB (rear) terminal on this player.
• When a software update is performed, the
software update data must be written onto the
USB memory device in advance using a PC.
• The USB memory device must be clear of all
les except software update data to allow new
software uploading.
To check for the availability of a software
update, visit http://www.onkyo.com
• When software update data is released, copy
the data onto a USB memory device after
downloading it to a PC.
• For methods such as downloading and copying
to a USB memory device, carefully read the
description shown on the website before
performing the operation.
NOTE
• Do not extract the rmware update le to any
folders other than the root directory on the USB
memory device. The rmware update le must
be only one le directly in the root directory.
When you insert or remove a USB memory device,
be sure to turn the main power off.
1. Insert the USB memory device with the update
le into the USB (front) terminal on this player.
USB memory
device
NOTE
• A USB memory device can be used with either
the USB (front) or USB (rear) terminal. When
two USB memory devices are connected to both
terminals at the same time, in certain situations
the USB (rear) terminal may give priority to Local
Storage and the USB (rear) terminal cannot be
used for Software Update.
To Next Page
Loading...
