Onkyo CBX 300 - CD / MP3 Clock Radio - Basic Operation and Controls; Powering On and Off; Selecting Input Sources

En- 20
Basic Operation
To turn on the CBX-300, press the [STANDBY/ON] but-
ton on the CBX-300 or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the
CBX-300 to Standby. The STANDBY indicator lights
up.
Press the VOLUME Up [ ] button to increase the vol-
ume or the VOLUME Down [ ] button to decrease it.
You can also use the remote controller’s VOLUME
[ ]/[ ] buttons.
The adjustable range is: Min, 1 through 43*, Max.
*Depending on the Maximum Volume setting, this value
can be 43 through 49 (see page 48).
You can select CD, iPod, FM, AM, or LINE, which can
be an external component.
To select the input source, press the remote controller’s
INPUT [ ]/[ ] buttons repeatedly. On the CBX-300,
press the [INPUT] button repeatedly. The input sources
are selected in the following order.
Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
You can adjust the volume and mute the sound as nor-
mal.
The speakers output no sound while the headphones are
connected.
VOLUME
STANDBY/ON
INPUT
STANDBY indicator
(front panel)
VOLUME
/
STANDBY/
ON
INPUT
/
PHONES
(rear panel)
Turning On the CBX-300
Adjusting the Volume
Remote
controller
CBX-300
Remote
controller
CBX-300
Selecting the Input Source
Using Headphones
CD FMiPod AM
LINE
PHONES jack
CBX-300EnFrEs.book Page 20 Friday, September 14, 2007 9:26 AM