16
1
2
Programming radio stations
For example to enter a station at 98.00MHz
(FM) into number 2 of the preset memory.
1. Select the FM band.
Press the TUNER button on the
CR-185X.
2. Select the frequency.
By holding down either √ TUNING/
PRESET ® button (for a second or more),
the auto tuning system will work and the
frequency display automatically stops
when a station is tuned in. To tune in the
frequency better, press the TUNING/
PRESET ® or √ TUNING/PRESET
button while the frequency flashes on the
display.
3. Press the MEMORY button and select
the station number.
After pressing the MEMORY button,
press the TUNING/PRESET ® button to
increase the station number or press the
√ TUNING/PRESET button to decrease
the station number.
• Press the MEMORY button within 8 sec-
onds, or else the memory mode will be
cancelled.
• Be sure not to hold down the MEMORY
button, or else the auto memory mode
will start accidentally.
4. Press the MEMORY button again.
If a frequency has already been stored in
the station number, it will be replaced by
the new one.
• Repeat steps 2 - 4 to continue program-
ming.
Note:
• If the FM station received is an RDS
station with a PS (Program Service name),
the frequency display will not change.
(Refer to page 18 for more details on the
RDS function.)
CD RECEIVER
VOLUME
TUNER
CD/LINE
TAPE/MD MIN
MAX
SYSTEM
PHONES
STAND-BY/ ON
AUTO / MONO
DISPLAYMEMORY
TUNING / PRESET
1
3, 4
2
TUNER
FM
Remote control
3
4
MEMORY
STEREO
kHz
MONOAUTO
MEMORY
STEREO
kHz
MONOAUTO
MEMORY
TUNING / PRESET
MEMORY
STEREO
kHz
MONOAUTO
turned off
Listen to the Radio
Down Up
TUNING / PRESET
STEREO
MHz
AUTO
To Next Page
Loading...
