18
Powering Up and Setting the Clock—
Continued
For European models:
If you cannot set the clock by using the ACCUCLOCK
function, you can set it manually. In this case, the
ACCUCLOCK function will not automatically cali-
brate the clock each day.
1
Press the [TIMER] button repeatedly until
“CLOCK” appears.
Only for European models:
Press the [ENTER] button and use the Up/Down [ ]/
[ ] buttons to select “MANUAL ADJ.”
2
Press the [ENTER] button.
The day of the week flashes.
3
Use the Up/Down [ ]/[ ] buttons to select
a day.
4
Press the [ENTER] button.
The time flashes.
5
Use the Up/Down [ ]/[ ] buttons to set
the time.
6
Press the [ENTER] button to set the clock.
“ADJUSTED” appears on the display.
1
Press the [CLOCK CALL] button.
The date and time appear on the display.
Press the [CLOCK CALL] button again to return to the
previous display.
You can set the CR-505 so that the time is displayed while
the CR-505 is in Standby mode.
1
With the CR-505 turned on, press and hold
the CR-505’s [STANDBY/ON] button for
more than 2 seconds.
To turn off the time display, repeat this procedure.
Note:
Setting the CR-505 to display the time will slightly increase
the power consumption in Standby mode.
Setting the Clock Manually
DIRECT
CD
To Next Page
Loading...
