Onkyo CR-505

25
Using the Radio— Continued
With the Auto Preset function you can automatically preset
all the FM stations available in your area.
1 Use the INPUT [ ]/[ ] buttons to select
FM.
2 Press the [MODE] button.
3 Use the [ ]/[ ] buttons to display “P-
EDIT,” and then press the [ENTER] button.
4 Use the [ ]/[ ] buttons to display
“A.PRESET,” and then press the [ENTER]
button.
Auto Preset function starts.
The Auto Preset function scans the FM band from low
to high, presetting up to 30 stations with strong signals.
Note:
All previously stored presets will be overwritten when the
Auto Preset function is used again.
Using the buttons on the CR-505:
1. Use the [INPUT] button to select FM.
2. Press the [MENU] button.
3. Turn the [ ] control until “P-EDIT” appears on the
display and then push the [ ] control.
4. Turn the [ ] control until “A.PRESET” appears on
the display and then push the [ ] control.
You can preset up to 40 of your favorite AM and FM radio
stations.
1 Tune into the station that you want to store
as a preset.
2 Press the [MODE] button.
3 Use the [ ]/[ ] buttons to display “P-
EDIT,” and then press the [ENTER] button.
4
Use the [ ]/[ ] buttons to display
“WRITE,” and then press the [ENTER] but-
ton.
The preset number flashes.
5 While the preset number is flashing, use
the [ ]/[ ] buttons to select a preset
from 1 through 40.
You cannot choose any preset number that has already
been registered for either the FM or AM station.
6 Press the [ENTER] button to store the sta-
tion.
The station is stored and the preset number stops flash-
ing.
Repeat this procedure for all of your favorite radio sta-
tions.
Note:
For European models, when the CR-505 is tuned into a sta-
tion that’s transmitting PS (Program Service Name) RDS
information, the station’s name will be displayed instead of
the frequency.
Using the buttons on the CR-505:
1. Tune into the station that you want to store as a preset.
2. Press the [MENU] button.
3. Turn the [ ] control until “P-EDIT” appears on the
display and then push the [ ] control.
4. Turn the [ ] control until “WRITE” appears on the
display and push the [ ] control.
5. While the preset number is flashing, use the [ ]
control to select a preset from 1 through 40.
6. Press the [ ] control to store the station.
You can select previously stored presets as follows.
Using the CR-505
1 Turn the [ ] control to select presets.
Using the remote controller
1
Use the PRESET [ ]/[ ] buttons to
select presets.
Presetting FM Stations Automatically
Presetting Stations Manually
/
/
/
/
Selecting Presets
/
/
/
/
/
/
/