> Before Start > Part Names > Install > Initial Setup > Playback
Supplementary information | Advanced Setup |Others
41
En
Timer
Set the time (ÄP15) and make settings for the alarm. (ÄP34)
System Infomation
The MAC address of this unit and the current firmware version will be displayed.
Factory Reset
Reset the settings of this unit to the status at the time of shipment. We recommend
that you take a note of the settings you have changed before going ahead with a
factory reset. Select "Yes" and confirm to go ahead. The unit will be placed on
standby automatically when initializing is completed.
Update
You will not be able to select "Update" if there is no firmware update.
∫ via Network
Press ENTER to select when you want to update the firmware via network.
∫ via USB
Press ENTER to select when you want to update the firmware via USB.
Pairing Information You can initialize the pairing information saved on this unit.
Press 3/4 to select "Clear", then press ENTER to initialize
the pairing information stored in this unit.
0 This function does not initialize the pairing information on
the BLUETOOTH wireless technology enabled device.
When pairing the unit again with the device, be sure to
clear the pairing information on the BLUETOOTH wireless
technology enabled device in advance. For information on
how to clear the pairing information, refer to the
BLUETOOTH wireless technology enabled device's
instruction manual.
To Next Page
Loading...
Need help?
General
