73
Causes RemediesSymptoms Pages
DVD Player
Remote Controller
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to external noise or static
electricity. If this happens, press the POWER switch on the unit and then press it again after about five seconds.
The disc containing the
MP3 tracks won't play.
Some MP3 tracks appear
to be missing from a disc.
The buttons on the DVD
Player operates but the
buttons on the remote
controller do not operate.
• The disc containing the MP3 tracks is not
formatted in ISO9660.
• The disc is not recorded in MP3 (MPEG-1
Audio Layer 3) format with a 32, 44.1 or
48kHz fixed bit rate.
• The track name does not end in “.mp3” or
“.MP3”.
• More than 251 folders and tracks are
recorded on a disc.
• A multi-session disc is inserted.
• No batteries are inserted in the remote
controller.
• The batteries are worn out.
• The remote controller is not pointed at the
remote sensor of the DVD Player.
• The remote controller is too far from the
DVD Player.
• Check that the track(s) are in the MPEG1
Audio Layer 3 format.
• Check that the sampling rate of the
track(s) are 44.1 or 48kHz.
• This system will not recognize file that
does not end in ".mp3" or ".MP3" as an
MP3 track. Change the track name.
• This player only recognizes the first 250
folders and tracks on a disc. If there are
more folders/tracks than this, you will not
be able to play them.
• This player is not compatible with multi-
session discs. If the disc is multi-session,
you will only be able to play tracks
recorded onto the first session.
• Insert new batteries.
• Replace with new batteries.
• Point the remote controller at the remote
sensor of the DVD Player.
• Operate the remote controller within 5 m.
–
–
7
7
7
9
9
9
9
To Next Page
Loading...
Need help?
General
