Onkyo FR-V77

52
Messages
The following table explains the messages that
appear in the display.
Message Meaning
Blank Disc A recordable MD without disc or track names is
inserted.
Cannot Copy An attempt was made to make a second digital
copy from a digitally dubbed MD (see “Rules for
digital recording” in the right column).
Cannot Edit You tried to edit a playback-only disc.
Cannot Rec You tried to record onto a playback-only disc.
Cannot Set You tried to set a timer while another timer is
operating.
D. In Unlock The digital equipment (CD player, DAT, etc.) is not
connected properly, or else not operating properly.
Disc Error The disc is abnormal (scratched or missing a TOC).
Disc Full The disc is full (see “System limitations” on page 54).
Full You tried to enter a character over the maximum
character capacity while naming.
Impossible You tried to edit a disc using a function not
available due to some reason other than the MD
system limitation.
MD Writing The unit is writing the recorded or edited contents
to the MD.
Mecha Error An error occurred in the unit’s internal mechanism.
Memory Full You tried to store a 26th track or a 31st channel.
Name Full The naming capacity of the disc or unit has
reached its limit.
No Change The name has not been changed.
No Disc There is no disc in the unit.
No Track The inserted disc has a disc name but no tracks.
Over In pause mode (when playing is paused),
(Fast Forward) was pressed to the end of the disc.
Protected The inserted disc is record-protected.
Recording You tried to switch to another source while
recording or perform a CD or tuner operation that
is disabled during recording.
Retry Error The recording attempt failed due to consecutive
disturbances from scratches on the MD or from
applied vibration.
Sorry You tried to (a) combine tracks that cannot be
combined, (b) divide a track at its beginning, or (c)
edit a disc using a function not available due to MD
system limitations.
Time Protect You tried to repeat double-speed dubbing using the
same CD.
TOC Error The reading of the disc or the recording onto the
disc failed.
Others
Energy Save Function
This function reduces power consumption while the
FR-V77 is in standby mode.
Press ENERGY SAVE while the FR-V77 is in stand-
by mode. The Energy Save indicator flashes and the
unit enters Energy Save mode in one minute.
If the Energy Save indicator is lit while the FR-V77 is
turned on, pressing STANDBY/ON causes the unit to
enter Energy Save mode in one minute. The display is
turned off in Energy Save mode, but the timer still
functions.
Note:
• Even if the Energy Save indicator is lit while the FR-
V77 is turned off, the unit will not enter Energy Save
mode.
• If you press ENERGY SAVE while the Energy Save
indicator is flashing, the unit enters standby mode.
• Only STANDBY/ON and ENERGY SAVE are
enabled in Energy Save mode.
• If the FR-V77 is in Energy Save mode and you
unplug then re-plug the power cord, the unit will
remain in Energy Save mode.
The message
turns off.
Energy Save
On
one minute
Energy Save
indicator
Display
Flashes
slowly.
“ENERGY SAVE”
scrolls once.
Energy Save
mode
Energy
Save
Indicator
ENERGY
SAVE