Onkyo HT-RC440(B) - Debug Mode-1: Audio Debug Mode; Entering Debug Mode

TX-NR414/ 515/ 515AE/ 616/ 616AE/ HT-R758/791/ HT-RC440/460/470
DEBUG MODE-1
AUDIO DEBUG MODE-1/6
To set in Debug mode
1. Press and hold down DISPLAY button, then press ON/STANDBY button.
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
4. Press DISPLAY button.
5. Press DISPLAY button.
6. Press DISPLAY button.
7. Press DISPLAY button.
8. Press DISPLAY button.
9. Press DISPLAY button.
10. Press DISPLAY button.
11. Press DISPLAY button.
D1 . 05 / 12 3 27 A EA
M1 . 06 / 12 4 17 A E
AUDIO dubug mode
The status of DSP and DIR etc
will be displayed.
0A 0 00 2 :_ _ :0 0 __
e.g.
The version number of microprocessor is displayed
only for 3 seconds.
ON/STANDBY DISPLAY
+ (TONE)
The version number of DSP is displayed
only for 3 seconds.
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
DSP dubug mode
STEP-1
DSP dubug mode
STEP-5
Exit
DSP dubug mode
STEP-8
DSP dubug mode
STEP-4
DSP dubug mode
STEP-3
DSP dubug mode
STEP-2
DSP dubug mode
STEP-7
DSP dubug mode
STEP-6
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
AN A :o : NO N :C : __
1: A NA _ 04 8 k0 4 8k
2/ 0 .0 : _2 . 0: 3 /4
2: o :P C M_ : PC M __
_0 0 :x : F: O FF _ __
SP 0 0F _ 00 F 00 4 09
_4 8 _4 8 25 6 ST B __
TX-NR414/515/515AE
HT-R758/791
HT-RC440/460
TX-NR616/616AE
HT-RC470
ON/STANDBY
+ (TONE)
DISPLAY