36
First Time Setup
If you connect to a COMPONENT VIDEO IN, you must
assign it to an input selector. For example, if you connect
your DVD/BD player to COMPONENT VIDEO IN 2,
you should assign it to the DVD/BD input selector.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
To enjoy Dolby Digital and DTS, you must connect your
DVD/BD player to the AV receiver by using a digital
audio connection (coaxial or optical).
Here are the default assignments.
With this function, you can assign digital inputs to input
sources. For example, if you connect your DVD/BD
player to DIGITAL IN OPTICAL 1, you’ll need to
assign that input (OPT1) to the DVD input source.
You can change the assignments as follows.
Component Video Input Setup
Input selector Default assignment
DVD/BD IN1
VCR/DVR -----
CBL/SAT IN2
AUX -----
TV/TAPE -----
CD -----
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [q]/[w]
buttons to select
“1.Component”, and then press
[ENTER].
3
Use the Up and Down [q]/[w]
buttons to select an input
selector, and use the Left and
Right [e]/[r] buttons to select:
IN1: Select if the video component
is connected to
COMPONENT VIDEO IN 1.
IN2: Select if the video component
is connected to
COMPONENT VIDEO IN 2.
-----: Select if you’re not using the
COMPONENT VIDEO
OUT.
4
Press the [SETUP] button.
Setup closes.
Digital Input Setup
Input selector Default assignment
DVD/BD COAX
VCR/DVR -----
CBL/SAT OPT1
AUX -----
TV/TAPE -----
CD OPT2
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
SETUP
RECEIVER
qwer
ENTER
To Next Page
Loading...
Need help?
General
