17
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Notice
• Do not place objects on the speaker system. The speaker system may drops
or fall over by losing balance and may cause an injury.
• Do not place on a shaky platform, sloping surface, or other unstable place.
The speaker system may drop or fall over by losing balance and may cause
an injury.
• Please select an installation site that has stable oor. If placed on a long-ber
carpet, the bers may contact the oscillator panel and cause irregular noise.
• Install the unit away from the tuner's antenna cable. Noise may be generated
if the two are too close together. If this happens, keep the main unit away from
the antenna and antenna cable.
• If a television or other device is nearby, noise interference may be produced
by the speakers due to electrical interference, etc. even if audio device power
is disconnected. If such noise interference is problematic, further separate the
speakers.
• The speaker unit for this product uses an extremely strong magnet. Do not
place drivers or other metallic objects near the front of the speaker system.
Doing so may cause injury from objects being attracted or damage the
oscillation panel. Moreover, do not place cash cards, oppy disks, or other
magnetic media near the speaker. The magnetic eld may cause those items
to be unusable or lose data.
• This unit is not designed with anti-magnetic shielding. Nearby CRT televisions
and computers may experience screen color distortion due to the presence the
magnetic eld. In such cases, move the speakers further away before use.
• This unit is capable of regular music playback. However, if any of the following
special signals are input, circuits may burnout due to excessive current.
Please exercise caution.
1. Noise resulting from incorrect FM channel reception
2. Noise from oscillator, electronic music device, or other high-frequency
component
3. Audio Check CD and other special signal sounds
4. Feedback from microphone
5. Sound produced when tape recorder is fast forwarded
6. When amplier is reverberating
7. Shock sound when plugging and unplugging pin cord or other connection
jacks
Maintenance
Periodically wiped the top and side surfaces of this product with a soft cloth.
When particularly dirty, soak the cloth in a diluted neutral cleaning solution and
squeeze out excess liquid before cleaning. Then, nish wiping with a dry cloth.
If using a chemical cloth, please read the warning label axed to the cleaning
product.
To Next Page
Loading...
Need help?
General
