Onkyo HT-S3910DAB User Manual

75
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Surround 150 Hz Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
LPF of LFE 120 Hz Set the low-pass lter for LFE (low-frequency
e󰀨ect) signals in order to pass only the lower
frequency signals than the set value, and thus
cancel unwanted noises. The low-pass lter is
e󰀨ective only on sources with LFE channel.
The value from "80 Hz" to "120 Hz" can be set.
"O󰀨": When this function is not used
Double Bass On This can be selected only when "Conguration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"O󰀨": Bass output is not boosted.
 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 3.60 m Specify the distance between each speaker and
the listening position.
Center 3.60 m Specify the distance between each speaker and
the listening position.
Front Right 3.60 m Specify the distance between each speaker and
the listening position.
Height Left 2.70 m Specify the distance between each speaker and
the listening position.
Height Right 2.70 m Specify the distance between each speaker and
the listening position.
Surround Right 2.10 m Specify the distance between each speaker and
the listening position.
Surround Left 2.10 m Specify the distance between each speaker and
the listening position.
Subwoofer 3.60 m Specify the distance between each speaker and
the listening position.
• The unit of distance can be changed by pressing the MODE button on the remote
controller. When using the unit "feet", the setting is available in increments of 0.1 ft from
0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of
0.03 m from 0.03 m to 9.00 m.

Onkyo HT-S3910DAB Specifications

General

Brand	Onkyo
Model	HT-S3910DAB
Category	Home Theater System
Language	English