85
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item Default Value Setting Details
Dolby Enabled
Speaker to Ceiling
6.0 ft Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
AccuReex Off You can enhance the reection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
• This setting can be selected when "Conguration" - "Height Speaker" is set to "Dolby
Speaker".
6. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value Setting Details
Speaker
Virtualizer
On "On": Listening modes such as T-D that have virtual
speaker effects can be selected.
"Off": Listening modes such as T-D that have virtual
speaker effects cannot be selected.
3. Audio Adjust
1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit’s display.
Mono Input
Channel
Left + Right Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
To Next Page
Loading...
Need help?
General
Weight and Dimensions
