8
To play a tape
A
Listening to a tape
1. Press the EJECT button to open the
cassette holder.
2. Insert a cassette.
• The side of the cassette with the
exposed tape should be facing down-
ward.
3. Set the Dolby NR by pressing the
DOLBY NR button repeatedly until
the proper Dolby NR indicator (B or
C) turns on or off.
• Select the same noise reduction system
that was used when the cassette was
recorded. For instance, tapes recorded
using Dolby B NR should be played
back with Dolby B NR.
4. Press the REVERSE MODE button
if you wish to select the auto reverse
mode.
“ b " turns off: Only one side of the
tape is played back.
“ b " turns on: Both sides of the tape
are played back repeatedly eight
times or until the e button is
pressed.
5. Start playback.
• Press the a or s button depending
on which side of the cassette you wish
to listen to.
s : Playback starts from the front
side.
a : Playback starts from the reverse
side.
• The auto-stop mechanism will auto-
matically stop the tape (depending on
the tape transport mode) if a tape is
played through to the end.
1
5
4
3
2
EJECT
When this unit is properly connected to the CD reciever CR-185X/CHR-185X, pressing the s button swiches input selector of CR-185X/CHR-185X to
“TAPE/MD” automatically.
1
4
3
5
d , f
2
REVERSE
MODE
DOLBY NR
B
C
Note:
To eject the tape in play, be sure to first
press the STOP button to stop the tape
transport before pressing the EJECT button.
To Next Page
Loading...
