Onkyo P-308 Instruction Manual

“WARNING”
‘BEFORE TURNING POWER ON,
CHECK ONCE AGAIN THAT THE
UNIT CAN BE USED WITH THE
LOCAL POWER SUPPLY. REFER TO
THE POWER SUPPLY RATING IN
THE SPECIFICATIONS AND THE
VOLTAGE SELECTOR SECTION FOR
DETAILS.”’
Installation and Handling
Observe the following precautions to obtain trouble-
free performance for many years.
1. Avoid places subject to direct sunlight or extreme-
ly high or low temperatures.
2. Avoid damp or dusty places and places directly af-
fected by vibrations from the speakers. In particu-
lar, avoid placing the unit on or above one of the
speakers.
3. Avoid unstable locations and high places from
which the unit could fall.
4. Ventilation — The unit should be situated so that
its location or position does not interfere with
proper ventilation. For example, the unit should
not be placed on a bed, sofa, rug or similar sur-
face that could block the ventilation openings or
placed in a built-in installation, such as a book-
case or cabinet, that could impede the flow of air
through the ventilation openings.
5. Heat — The unit should be situated away from
heat sources such as radiators, heat registers,
stoves or other appliances (including amplifiers)
that produce heat.
6. Cleaning of the internal parts should be performed
only by qualified service personnel.
7. Spillage — Care should be taken so that objects
do not fall and liquids are not spilled into the en-
closure through the openings.
8. Damage Requiring Service — The unit should be
serviced by qualified service personnel when:
“CAUTION”
“TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.”
A. The power supply cord or the plug has been
damaged; or
Objects have fallen or liquid has been spilled
into the unit, or
C. The unit has been exposed to rain, or
D. The unit does not appear to operate normally
or exhibits a marked change in performance, or
E. The unit has been dropped or the enclosure
damaged.
9. The user should not attempt to service the unit
beyond the procedures described in the operating
instructions. All other servicing should be referred
to qualified service personnel.
wo
Care
From time to time you should wipe off the front and
rear panels and the cabinet with a silicon or other
soft cloth. For heavier dirt, dampen a soft cloth in a
weak solution of mild detergent and water, wring it
out dry, and wipe away the dirt. Following this, dry
immediately with a clean cloth. Do not use rough
material, thinner, alcohol or other chemical solvents
or cloths since these may damage the finish or re-
move the panel lettering.
Note:
AC Fuses
The fuses are located inside the chassis and are not
user serviceable. If power does not come on, contact
your Onkyo dealer.
***WARNING***
BEFORE TURNING ON POWER FOR THE FIRST
TIME, READ THE FOLLOWING SECTION CAREFULLY.
a)
Some models are designed for use only with the power
supply voltage of the region where they are sold.
Canadian models: AC 120V, 60Hz
European models: AC 220V, 50Hz
British and Australian models: AC 240V, 50Hz
Worldwide models: AC 120V, GOHz/AC 220V, 50Hz
Voltage Selector (rear panel)
Worldwide models are equipped with a voltage
selector to conform with local power supplies. Be
sure to set this switch to match the voltage of the
power supply in your area before turning the power
switch on. Voltage is changed by sliding the groove
in the switch with a screwdriver or similar instru-
ment to the up or down position. Confirm that the
switch has been moved all the way up or down
before turning the power switch on. If there is no
voltage selector switch on the unit you have pur-
chased, it can only be used in areas where the pow-
er supply voltage is the same as that of the unit.
220V ~ | 220V ~
8 at AC 220V at AC 120V
120V ~ 120V ~
FOR POWER SUPPLY CORDS WITHOUT PLUGS:
Replacement and mounting of an AC plug on the
power cord of this unit should be performed only by
qualified service personnel.
e IMPORTANT: The wires in the power cord (mains
lead) are colored in accordance with the following
code:
Blue: Neutral
Brown: Live
As the colors of the wires in the power cord of this
unit may not correspond with the colored markings
identifying the terminals in your plug, proceed as
follows:
The wire which is colored blue must be connected
to the termina! which is marked with the letter N or
colored black.
The wire which is colored brown must be connected
to the terminal which is marked with the letter L or
colored red.

Onkyo P-308 Specifications

General

Brand	Onkyo
Model	P-308
Category	Amplifier
Language	English