Advanced Settings
29
Setting Item Default Value Setting Details
Height 1 None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
The setting will be fixed to "None" if "Height 1
Speakers Type" is set to "Not Use".
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP ".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
If any type is selected in "Speaker Settings" -
"Height 1 Speakers Type", this setting will be set
to "80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".
Height 2 None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
The setting will be fixed to "None" if "Height 2
Speakers Type" is set to "Not Use".
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP ".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
If any type is selected in "Speaker Settings" -
"Height 2 Speakers Type", this setting will be set
to "80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
Select a value between "80Hz" to "120Hz".
"Off": Do not use this function
Setting Item Default Value Setting Details
Subwoofer Phase 0° Bass sound of the subwoofers may be insufficient
depending on the type of sound and the listening
position. In that case, change the phase of
subwoofers. Set the phase value while listening to
the sound so that you can obtain your preferred
bass sound.
"0°": The subwoofer is in normal phase.
"180°": The subwoofer is in reverse phase.
r
The setting cannot be changed if "Subwoofer" is
set to "No".
Double Bass ----- Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted.
"Off(THX)": Bass output will not be boosted.
r
The setting will not automatically be configured even
if you performed the automatic speaker setup.
r
If "Subwoofer" is set to "No" or if "Front" is set
to other than "Full Band", the setting cannot be
changed.
r
If you're using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz(THX)" in LPF of LFE.
– Set a value "Off(THX)" in Double Bass.
To Next Page
Loading...
Need help?
General
