Onkyo T-411RDS-409 User Manual

mm -'mm* -
Connecting an FM outdoor
^antenna ■ .. w
A . * ** ««ai
If the reception is not very clear with the
attached T-shaped FM antenna, the use of
an external antenna is recommended.
Please make sure that you comply with the
following considerations regarding the
location.
Keep the antenna away from noise sources
(neon signs, busy roads etc.)
It is dangerous to put it close to power
lines, so keep it well away.
Connecting a 75/300 ohm
antenna adaptor ^ 1
Please refer to the following procedure
when connecting a 75/300 ohm antenna
adaptor. (This adaptor is included if your
T-411 RDS/T-409 is a worldwide model.)
Connecting the coaxial cable
1. Prepare the coaxial cable as shown.
2. Using your fingernail or a small
screwdriver, remove the cover.
Connect the 75/300 ohm antenna adap¬
tor to the coaxial cable and replace the
cover.
© Insert the end of the cable.
(2) Clamp in place with pliers.
Connecting the power
2
1
Connecting the power
1. When you connect the power cord to
the wall outlet, u 0:00” will light up on
the display.
2. Press the POWER button. The dis¬
play will light up.

Onkyo T-411RDS-409 Specifications

General

Brand	Onkyo
Model	T-411RDS-409
Category	Tuner
Language	English