What to do if my Onkyo TX-DS474 has power but no sound?
If your Onkyo Receiver powers on but produces no sound, there might be several reasons. Ensure that the TAPE MONITOR and MUTING indicators are off by pressing the TAPE (MONITOR) and MUTING buttons. Verify all connections and speaker leads. If the ‘PROTECT’ message is displayed, the amplifier protection circuitry may have been activated.
Why is there no sound from the playback source on my Onkyo Receiver?
If you can't hear the sound of the playback source on your Onkyo Receiver, the input selector might not be set properly. Set it to the correct playback source.
How to fix hum or low-frequency noise on Onkyo TX-DS474?
To address hum or low-frequency noise with your Onkyo Receiver, check the outer conductor of the input plugs and ensure a proper ground connection. Adjust the placement of the audio connection cables on the rear panel to reduce hum.
How to stop buzzing noise on AM with Onkyo TX-DS474 Receiver?
If you are experiencing buzzing noise on AM with your Onkyo Receiver, especially at night or with weak stations, it could be due to noise from electrical apparatus such as a fluorescent lamp. Try moving the AM loop antenna to a different position or setting up an outdoor AM antenna.
How to troubleshoot no power on my Onkyo TX-DS474?
If your Onkyo Receiver has no power, check the power cord to ensure it is properly connected. If there is external noise in the circuits, try turning the power off and on again, or unplugging and re-plugging the unit. If the AC fuse is blown, contact your Onkyo Service Center.
Why is there no sound from the center speaker on my Onkyo Receiver?
If you're getting no or minimal sound from the center speaker of your Onkyo Receiver, first check the speaker cable connections. Make sure the SURROUND MODE is set to DOLBY PRO LOGIC, HALL, LIVE, or ARENA, and not STEREO. Adjust the CENTER level to an appropriate volume and ensure the CENTER SPEAKER is set to YES.
What to do if the Onkyo TX-DS474 Receiver remote is not working?
If the front panel controls on your Onkyo Receiver are working, but the remote controller isn't, the batteries may be missing or worn out. Try inserting or replacing the batteries in the remote controller.
Why do the TUNED and STEREO indicators flicker on my Onkyo Receiver?
If the TUNED and STEREO indicators on your Onkyo Receiver flicker and you hear a hiss on FM, the station may be too weak. Because stereo FM broadcasts cover only about half the distance of an ordinary broadcast, try installing an outdoor FM antenna or changing its position or direction.
Why is the sound distorted on my Onkyo TX-DS474 Receiver?
If the TUNED and STEREO indicators are lit but the sound is distorted and stereo separation is poor on your Onkyo Receiver, the station signal may be too strong, or there could be multiple reflections of radio waves due to tall buildings or mountains. Try changing to a T-shaped antenna or use an antenna with better directivity, selecting a point where the distortion is least.
How to eliminate crackling noise on AM/FM on Onkyo TX-DS474 Receiver?
If you hear crackling noise on AM or FM with your Onkyo Receiver, it may be caused by turning a fluorescent lamp on and off, or noise from automobile ignition. Try moving the antenna as far as possible from the fluorescent lamp. Install an FM outdoor antenna as far as possible from the road and consider changing its position or direction.
General| Audio Channels | 5.1 |
|---|---|
| Frequency response | 10 Hz - 100 kHz (+1 dB, -3 dB) |
| Total harmonic distortion | 0.08% |
| Digital inputs | 2 optical, 1 coaxial |
| Input sensitivity | 200 mV |
| Signal to noise ratio | 100 dB |
| Video Connections | composite |
| Weight | 11 kg |
To Next Page
